These are some fundamental measuring and marking tools that you should have if you're just getting started with Woodworking.
Measuring Tape
Having a measuring tape on hand makes it easier to collect measurements on the spot. Measuring tapes are offered in two formats: "Imperial" and "Standard"/metric. 16 feet, 25 feet, and 30 feet are common lengths.
Ruler
Keep at least one decent Ruler in your studio at all times. A ruler will be used for a variety of activities, including plan design, material measurement, table saw wing alignment, and surface regularity inspection, among others. Investing in a steel Ruler is usually a good idea.
Square of Combination
A combination square is a wonderful investment if you are just getting started with Woodworking.
A combination square can be used to measure 90° and 45° angles, flatness, and the center of a circular bar, as well as mark the work surface.
1) a square head and 2) a steel ruler make up a conventional combination square. It can depth gauge or transfer dimensions by sliding the square head along the steel ruler.
Square Framing
Another useful tool to have is a framing square (also known as a steel square or carpenter's square). It is composed of steel and has two arms: a long arm and a short arm that meet at a 90-degree angle.
You can use a framing square to measure any construction design you require. Framing squares with a 24-inch blade and a 16-inch tongue are the most common. There are smaller versions as well, however, they do not have the frame tables.
Gauge for marking
Before cutting, the marking gauge is used to draw lines. You can draw a line parallel to a reference edge with it. A beam, headstock, pin, pin, wheel, and knife are all common components of a marking gauge.
Scratch Awl
The scratch awl is essentially a sharp-tipped steel spike. It carves a shallow groove in the wood that you may follow with a chisel or hand saw.
Sliding Bevel
Woodcutting will be considerably easier and smoother with a sliding bevel. The sliding bevel is essentially a gauge for setting and transferring angles. It is made up of a handle, which is commonly made of wood or plastic, and a metal blade that can be adjusted.
Knife
Chairmakers have traditionally employed the Drawknife cutting tool. It normally has a straight blade that is 8-12 inches long with perpendicular handles on both ends.
The Froe (also known as the lathe ax or splitting knife) is a riveting and splitting tool. The froe features a perpendicular handle at the end of an 8-12 inch long straight blade.
The Scorp is a drawknife with a blade that is almost entirely round. It's quite useful for hollowing out bowls and other similar things.
The Utility Knife is a knife with a retractable blade and a metal grip. The utility knife, which comes in a variety of sizes, is used in woodworking to cut a variety of materials.
Gauge Dial
A caliper having a dial reading in hundredths or thousandths of an inch is referred to as a dial gauge. It can be used to determine the depth of a hole. Precision measurements from cylindrical tenons and mortises are a breeze with this instrument.
Are you just starting out with woodworking? To obtain a collection of over 16,000 plans, go to teds woodworking plans .