Easy How to Use Kreg Jig Guidance
In wood-related projects, having a tool to make holes is essential. Many beginners and also professionals are suggesting using a Kreg Jig. It could be as handy as people describe under one condition: you know how to operate it. If you don’t, then it would sit in the corner of your storeroom only.
The first step to do is measuring how thick the wood you are going to drill. In the manual book, you will find different screw sizes to use. Sometimes, you could use a thinner screw if the wood has a less solid structure. You might have to connect two kinds of wood with different thicknesses. In this case, pick the thinner screw to drill both boards.
Depending on the thickness, you might need to readjust the position of the holes. To do this, you have to loosen the screw so you could pull or push the jig. Place the board in between the jig and the bit collar, then tighten the jig grip. Before you start screwing, secure the Kreg jig by clamping the tool to the table. It is important to prevent any mistakes.
There are at least three guide holes in the bit collar. Each hole should be able to fit the screws perfectly. Using steady pressure, push the screw through the bit collar. If you need to drill more holes, move the position and repeat the process. The suggested holes number is two. One hole allows the board to spin around, using the hole as a pivot center.
In the basic drilling guidance, you must make sure that the board touches the bottom of the kreg jig machine. However, you could pull up the board a little bit to make joint holes. It would be helpful especially when you want to connect two kinds of wood. For beginners, it is better to drill the wood one by one. Once you master the skill, you could drill the connected joint at the same time.
To make strong furniture, you need a strong joint and connect the holes with a screw. This is where a Kreg Jig comes in handy. If you want a stronger hold while drilling, don’t forget to attach the clasping claws to the edge of the table. Also, remember to pick a suitable eye drill for the wood-based on its thickness. As long as you stay on these rules, there would be no problems with the hole-making process.